Home > News > Content

LED UV Nail Light Safety

LED UV nail light is suitable for use at home, on the go and at any time and place you feel convenient for self-help nail. Curing time, providing 10s, 20s, 30s timing selection.

Can be easily applied to fingernails or toenails.

1, LED UV nail light environmental protection, ordinary nail lamp is used in ultraviolet light, and LED is a semiconductor light-emitting devices, no harmful substances, but because of small size, LED UV Nail Lamp not broken, easy to handle waste.

2, LED UV nail light energy saving, LED is a low-power devices, the actual power consumption is very small, such as 2.5W products and the original 14W almost, so very energy saving.

3, safe, not hot, the original ordinary nail lights, customers are not careful when used very easy to hot, because the lamp in the light when the high heat generated, the general temperature of 50-70 degrees, LED UV Nail Lamp and some products to more than 80 Degree, once the human hand hit the lamp, it will burn, and LED is cold light source, when used without heat, even if the user to touch, it does not matter.

4, long life, ordinary nail lamp lamp life of the general 3000-5000 hours, and some tubes less than 3000 hours, so often for the lamp, more trouble, but also increase the use of cost, and LED Life is generally 35,000 hours, the use of up to 50,000 hours or more, do not often need to change the lamp so much trouble, saving the use of cost.

5, easy to carry, ordinary nail lamp as a result of the use of the lamp, is fragile, easy to damage the lamp when carrying, and LED is a solid material, LED UV Nail Lamp not because of damage and damage.

6, save time, this product uses LED nail glue, dry time for about 30 seconds, while the ordinary nail light dry time for 2 minutes to 3 minutes, significant savings in working hours.

LED UV nail light is relatively fast, but most of the current light therapy LED lights or not, and UV light a little longer, but the Barbie glue and light plastic can be used.

If the new light is not dry, it may be coated too thick, and each layer of plastic should be thin Tu.

And then the end of the general, LED UV Nail Lamp as the end of the lamp is not completely dry, it will still have a little sticky

Sealing, then, according to the need to clean the lamp with a clean cotton cleaning liquid scrub the next side of the remaining glue, to be cleaned before the dry thoroughly cured